AlarmDspLast not showing anymore

Hello,

I have a project in CitectSCADA 7.40 using the AlarmDspLast function to display alarm messages. It is programmed to show the last 6 messages, it was working fine until I aligned the six Cicode objects, since then it is not showing anything (sometimes a line shows but disappears easily).

Any suggestions to make the function AlarmDspLast work properly? Am I using it properly with the Cicode objects?

Thanks.

Parents

Patrick over 5 years ago

It is very well possible that your AN's are sequential in your template, but not in the actual page.
You could check this by opening the page in Graphics Builder and clicking on one of the AN's at a time while holding CTRL.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Patrick over 5 years ago

It is very well possible that your AN's are sequential in your template, but not in the actual page.
You could check this by opening the page in Graphics Builder and clicking on one of the AN's at a time while holding CTRL.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data