Reading data from PM810 over EGX150

Hi,

I am trying to read data from a PM810 meter connected through an EGX-150 gateway. I have tried with a generic Modbus driver, than tested with a generic Modbus scanner. The result is always the error code 04.

Have you encountered such a situation?

Thanks,

Arian

Parents

Arian over 6 years ago

Hi Olivier,

I've spend many hours to check what was going on, I've tested the PM810 separately from EGX, finally it was just a wrong configuration of the stop bits in EGX, the default value is 'auto', PM needed 1.

Thanks,

Arian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Arian over 6 years ago

Hi Olivier,

I've spend many hours to check what was going on, I've tested the PM810 separately from EGX, finally it was just a wrong configuration of the stop bits in EGX, the default value is 'auto', PM needed 1.

Thanks,

Arian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data