Multimonitor operations

Could you please try to set up and run ExampleSA project in your multi-monitor environment? Project ExampleSA is based on Situational Awareness templates (Workspace style) where all multi-monitor related parameters are enhanced for you to set up the desirable working environment in Plant SCADA Studio. The templates also support both 4k and 1080 resolution screens.

.

You may have to migrate your project to use the Situational Awareness environment for reliable multi-monitor support and it is not necessary to re-design all legacy graphics pages depending on the screen resolution of monitors. See the example of 1080 screen shown below where the content pane displays the SOE page of old Tab Style. It really depends on your requirements, such as if the resolution of content pane is good enough. However, you could design the layout to suit your needs (increase size of Content Page, for example). See the help of Plant SCADA 2023 release for details.

Hope this would help.

Regards,

Jacky

Thanks Jacky, I have set up the profile for my two screens and now I only get a single page on each monitor however I still cannot seem to get them to run at full screen ?

Have you tried [Animator]FullScreen = 1? By default it is set to 0.

I've some problem with that.
But youcan work with in the citect.ini.

But the setup Wizard overite it. (Always re setup this two after the Wizard).

Thanks Jacky and Jean-Marie, I think I have it running in full screen now on both monitors and did have issues with the wizard playing with the ini settings :)  I think the issue I have is the old project screen resolution won't work on the new screens with 1920 width. Not sure how I update all the old screens to the new screen resolution. I had to change the monitors resolution back to match the old screen res in builder. Would prefer to run in a higher resolution but think I need to update all the old version screens to the higher resolution.

You can setup Citect so that the run-time graphics will stretch to the 1920x1080 resolution.  We have many customers with 1024x768 graphics running on modern monitors for many years now

in the ini file set the following:

[Animator]FullScreen=1

[Page]DynamicSizing=1

[Page]MaintainAspectRatio=0

Greg, Have these set as above but still not showing full screen ?