Plant SCADA link variables and tags with unity Pro (Control Expert)

You have to activate the Data dictionary under project properties and use OFS and OFSOPC-protocol to communicate to the M340

Ok I will try that but does OFS and OFSOPC-protocol needs additional license?

OFS checks if there is a Plant SCADA Server license. If valid then the OFS is licensed. The OFSOPC-protocol is free of charge as most available drivers in Plant SCADA. Only tags add up to the pointcount and the size of the required license

Latest OFS for Plant SCADA doesn't require the presence of the license.

Ok thanks for the info. but does this work with M580 as well?

Ok thanks for the info. but does this work with M580 as well?

OFS works with M580.

If you have problem with communication, i will start with a test project and after you configured the OFS you can use the IO device wizard to create the IO dev, Port and Board as needed.

At this stage, everything should start working. If not, the best is to contact your local distributor that in Egypt is Schneider Electric.

Raise the ticket from SE.com and select chat on the support section.