Adding the Easergy driver into Citect 2018 R2?

Hi Simon Mungwira ,

Can you share more details about the I/O Device > Protocol configured within Power SCADA?

From what I can comprehend from the user manual (https://www.se.com/au/en/download/document/P3TDSxxxxxEN/) this device appears to support two protocols, namely:

DNP

IEC 60870-5-103

Plant SCADA does have the DNPR driver (DNP protocol) and a IEC870IP (IEC 60870-5-104 protocol). 

I think the DNPR driver might be your best option. Unfortunately there aren't any device templates like you have in Power SCADA, but you could easily export the variable tag configuration from Power SCADA and use it within Plant SCADA.

Here is a video of Power SCADA configuring Easergy with DNP: https://vimeo.com/311195484

Hi Simon Mungwira ,

Can you share more details about the I/O Device > Protocol configured within Power SCADA?

From what I can comprehend from the user manual (https://www.se.com/au/en/download/document/P3TDSxxxxxEN/) this device appears to support two protocols, namely:

DNP

IEC 60870-5-103

Plant SCADA does have the DNPR driver (DNP protocol) and a IEC870IP (IEC 60870-5-104 protocol). 

I think the DNPR driver might be your best option. Unfortunately there aren't any device templates like you have in Power SCADA, but you could easily export the variable tag configuration from Power SCADA and use it within Plant SCADA.

Here is a video of Power SCADA configuring Easergy with DNP: https://vimeo.com/311195484

Hi Olivier 

Thank you for the reply.

Within Power SCADA the I/O Device protocol is Easergy which does not exist in Plant SCADA. I however used MODNET protocol to retrieve the data. I had to get the modbus mapping for the P3 relays though. It was going to be easier if the Easergy protocol was readily available in Plant SCADA.