• State Suggested Answer
  • Replies 8 replies
  • Answers 1 answer
  • Subscribers 584 subscribers
  • Views 232 views
  • Users 0 members are here
Options
Related

Is there a command to autoscale pages depending on resolution of monitor(s)

Jan Lonij

Hello everybody,

I have made pages in fullHD 1920-1080.

Some of my clients have a monitor less then fullHD and the pages are only partially displayed.

Is there an 'autoscale' option in SCADA of can you display vertical or horizontal scroll bars?

Thanks for your aid.

Parents
  • 0

    Hi  ,

    I believe that your project is Workspace based and uses the start-up project. Here are the steps to change the display behavior.

    • Open Master_PageMenu page used in the project where you could see the layout
    • Right-click on the content pane
    • Select Genie Parameters and the following form will be displayed

    • Select Display Mode = MaintainAspectRatio
    • Turn off Scrollbars
    • Compile and restart the project

    I suggest that you should test this feature with ExampleSA project before rolling out it to your production project.

    Hope this would help.

    Regards,

    Jacky

Reply
  • 0

    Hi  ,

    I believe that your project is Workspace based and uses the start-up project. Here are the steps to change the display behavior.

    • Open Master_PageMenu page used in the project where you could see the layout
    • Right-click on the content pane
    • Select Genie Parameters and the following form will be displayed

    • Select Display Mode = MaintainAspectRatio
    • Turn off Scrollbars
    • Compile and restart the project

    I suggest that you should test this feature with ExampleSA project before rolling out it to your production project.

    Hope this would help.

    Regards,

    Jacky

Children
No Data
© 2025 AVEVA Group Limited or its subsidiaries. All Rights Reserved.