• Replies 4 replies
  • Subscribers 581 subscribers
  • Views 632 views
  • Users 0 members are here
Options
Related
set(True = false)

Citect SCADA 2018 R2 - Configure I/O Device Communications - Using Ethernet

Canh

Hello everyone,

I'm trying to configure the I/O Devices using an Ethernet connection. Follow the instruction as Citect SCADA web help from steps 1 to 3. I already finished it.

Move to the last step: Define the I/O Device units. The screen of the I/O Device setting shows that I have to fill in the address of the equipment again. The photo below

But the address I already define in step 2 of the instruction in the Ports form. The photo below

My question is: Do I need to fill the address again in the Configuration of I/O Device setting?

Best Regards

Canh

Parents
  • Sorry, I would like to up the photo again via this link: The sequence number of the photo is 1 2, and 3 according to the post from top to bottom.
    https://drive.google.com/drive/folders/1FoKhqzdViH3tvf-rHp8xSCyG79VmlVIW?usp=sharing

    Thank you
Reply
  • Sorry, I would like to up the photo again via this link: The sequence number of the photo is 1 2, and 3 according to the post from top to bottom.
    https://drive.google.com/drive/folders/1FoKhqzdViH3tvf-rHp8xSCyG79VmlVIW?usp=sharing

    Thank you
Children
No Data
© 2025 AVEVA Group Limited or its subsidiaries. All Rights Reserved.