set(True = false)

Citect SCADA 2018 R2 - Configure I/O Device Communications - Using Ethernet

Hello everyone,

I'm trying to configure the I/O Devices using an Ethernet connection. Follow the instruction as Citect SCADA web help from steps 1 to 3. I already finished it.

Move to the last step: Define the I/O Device units. The screen of the I/O Device setting shows that I have to fill in the address of the equipment again. The photo below

But the address I already define in step 2 of the instruction in the Ports form. The photo below

My question is: Do I need to fill the address again in the Configuration of I/O Device setting?

Best Regards

Canh

Parents

Richard J over 4 years ago

Hi Canh

as mentioned by Patrick

The driver reference gives you all the information you need for the form, in Citect Studio, go to the Topology, then select IO devices then select Driver Reference Help. Once that opens go to TITCPIP Driver > Simatic TI TCP/IP > Communications Forms
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Richard J over 4 years ago

Hi Canh

as mentioned by Patrick

The driver reference gives you all the information you need for the form, in Citect Studio, go to the Topology, then select IO devices then select Driver Reference Help. Once that opens go to TITCPIP Driver > Simatic TI TCP/IP > Communications Forms
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data