• Replies 2 replies
  • Subscribers 586 subscribers
  • Views 155 views
  • Users 0 members are here
Options
Related

Citect 2015 Runtime causes windows to restart

Mohab

The industrial PC (iPC) had a problem that is could not start up correctly after upgrading the windows version. This problem could be in windows or hard disk. The next procedure has followed to solve the problem.

First, Vijeo Citect SCADA license have been transferred to Schneider Electric Website. Next, the hard disk has been replaced and a new windows have been installed. Then the license has been transferred to the new hard disk. Finally, when start Vijeo Citect Runtime the iPC turn off and restart again. So, there is a hardware problem in the iP

Parents

  • Hi  ,

    Sounds like there could be a fault with the operating system. To be sure I would look at the Windows Event log to see what the fault was. It might be more efficient to simply re-install the OS, then install fresh copy of Citect. Then try run the Example project. If that is successful, do the last step of activating the license again.

    Wish you the best of luck.

    Kind regards

    Olivier

Reply

  • Hi  ,

    Sounds like there could be a fault with the operating system. To be sure I would look at the Windows Event log to see what the fault was. It might be more efficient to simply re-install the OS, then install fresh copy of Citect. Then try run the Example project. If that is successful, do the last step of activating the license again.

    Wish you the best of luck.

    Kind regards

    Olivier

Children
No Data
© 2024 AVEVA Group Limited or its subsidiaries. All Rights Reserved.