PlantScada "Out of Memory" when starting runtime from studio

Hi Rune ,

Can you share more information about what component experiences the "Out of memory"?

In theory the "run" from Studio or via shortcut should be the same.

I recommend reaching out to Customer Support to investigate this issue further.

Have a look at Windows Event Viewer for more details. The \Log\ folder syslog* for the component would also be a good place to start looking.

Kind regards

Olivier

Hi Olivier,

There was no specific info about what component. However I found out that it was related to user privilege's and how the computer where setup and if PlantScada was started with "Runs As Administrator" or not. In the end a computer clen-up and re-install of PlantScada will fix it. 

There was no specific info about what component. However I found out that it was related to user privilege's and how the computer where setup and if PlantScada was started with "Runs As Administrator" or not. In the end a computer clen-up and re-install of PlantScada will fix it.