Kepware + Citect 2018 (W10)

Hi everybody!

I am starting to use Kepware OPC Server. In my laptop is OK. I export my Citect application and config.ini in factory computer, and the variables are in BAD state. In Kernel, OPC IODevice is OK. I open Kepware OPC client and data are OK.... What is happening??? Firewall is desactivated... Maybe there somo OPC parameters that I should configure and in my laptop windows vwrsion is not exactly as in Factory computer....

Parents

Olivier over 1 year ago

Check that [OPC]UseOPC2=1 is enabled.

Run the computer setup wizard to make sure the IO Server is configured correctly.

Is the Kepware OPC Server on the local machine (to the IO Server)? If it is remote, you will need to configure DCOM. See the online help for DOMC settings:

gcsresource.aveva.com/.../OPC_DA_Server_DCOM_settings.htm
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Javier over 1 year ago in reply to Olivier

It is solved! I have had to install Upgrade 23. I had Citect 2018 without any upgrade. In other thre computers I have this same version running OPC protocol and no problem. Maybe the problem was mixing between OPc DA and OPC UA
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Javier over 1 year ago in reply to Olivier

It is solved! I have had to install Upgrade 23. I had Citect 2018 without any upgrade. In other thre computers I have this same version running OPC protocol and no problem. Maybe the problem was mixing between OPc DA and OPC UA
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data